Change History
PcOS Series 90PLUS
Programmer's Guide
Page ii
Rev Q
11/07/05
Corrected the description of the [ESC]J command. It does not start the next line at the left margin unless Auto-CR is on.
Updated the configuration table
Changed RS1284 references to IEEE-1284
Added Welsh and Thai character sets
Updated the cut command. The cutter does not have selectable cut. The cut command is now only 2 bytes.
Updated MICR section to include translation tables and field checking
Added 5 x 7 font to rotated print functions
Added sections on Windows Plug and Play
Added [ENQ]<20> (return all status) and [ENQ]<21> (return printer ID) commands
Added commands to allow the host to define a unique code page
Added autocutter position information
Added multidrop addressing
Added, “The cash drawer will only provide 1.0 amp at 24V.”
Rev. E
Update for Firmware Rev. 2.07
Added 50 international language code pages
Altered Character Sets I and II. The printer no longer supports Character Set I and II. The printer is always in Set II.
Changed IPCL &%CP to support 4-digit code page descriptions
Extended the EPOS [ESC]R to support enhanced language sets
Updated code page table descriptions
Removed the Prerelease Change History
Corrected minimum slip width specification in the text for Figure 4
Rev D
Update for Firmware Rev 2.05
Updated and clarified descriptions in the communication section
Added description of CTS and DSR controls
Added MICR commands and references to MICR Programmer’s Guide
Updated configuration section to include MICR and communication CTS/RTS/DTR/DSR options
Added [ESC]y<2> and <3> commands to switch between EPOS and Normal modes
Added 4-inch resume on paper out
Rev C
Update
Removed IPCL command for set rotated print line spacing
Shortened graphic-save buffer from 2014 characters to 2000
Removed second parameter of [ESC] [EM] B; set bar code height
Changed all validation and slip control IPCL commands to accept decimal parameters instead of binary
Removed set left and right margin IPCL commands
Removed set dynamic response from [ESC]y group and defined [ESC] to replace it
Updated inquire descriptions to reflect preprocessing of ENQ commands; previously, ENQ commands were processed with other commands.
Changed ENQ descriptions in the communication section to reflect command preprocessing
Reversed parallel port responses to ENQ 1, 2, 5, 6, and 11; updated CFG90 to match
Reversed serial port responses to ENQ 7 and 8; updated CFG90 to match
Redefined ENQ 9 to represent inquire buffer status
Added Epson mode [DLE] [EOT] and [DLE] [ENQ] commands
Rev B
Update
Added eject wait and pause commands and configuration information
Added print suppress and display pass-through to both EPOS and Normal modes
Updated CFG90 to deal with the new modes
Rev A
Initial Release
Summary of Contents for Ithaca 90PLUS Series
Page 2: ...Page ii Rev Q 11 07 05...
Page 12: ......
