General Specifications
PcOS Series 90PLUS
Programmer's Guide
Page 8
Rev Q
11/07/05
Supply
Voltage
Rating (VAC)
Supply
Voltage
Range (VAC)
Frequency
(Hz)
Rated
Power
(watts)
Current Idle
(amps)
Current Printing
(amps)
100 - 240
90 - 264
47 - 63
45
0.08 @ 120VAC
0.04 @ 240VAC
0.5 @ 120VAC
0.25 @ 240VAC
Table 2 Power input requirements
3.3.2
Interface Specifications
3.3.2.1
Serial
The serial interface is a standard RS-232 interface on a 9-pin, D-shell connector. It is defined as a
standard DTE device. A null modem cable is required to interface the printer to another DTE device (a
personal computer). See the serial port description later in this manual.
3.3.2.2
Parallel
The parallel port is a standard 25-pin, D-shell as defined in the IEEE 1284-A Standard. See the parallel
port description later in this manual.
3.3.2.3
Cash Drawer
The Series 90PLUS Printer supports dual cash drawers with status. The interface will provide status
and 24 VDC at up to 1.5 amps to the cash drawer. See the cash drawer interface description later in this
manual.
3.4
Media Specifications
3.4.1
Ribbon
Inking method
cartridge type, 70.9-inch (1.8 m) seamless ribbon with reinker
Ink color
black or purple
Ribbon life at 25
°
C
3 million (black) or 4.5 million (purple) characters to ink depletion
2
Manufacturer
Only Ithaca Peripherals approved ribbons should be used.
3.4.2
Receipt Paper
Paper feed method
friction feed
Paper feed pitch
default,
1/8
inch; can be set in units of
1/216
inch by software command
Paper width
2.5, 3.0, or 3.25 inches (63.5, 76.2, or 82.6 mm)
Roll diameter
3.5 inches (88.9 mm)
Paper thickness at 25
°
C 0.003 - 0.0035 inch (0.076 - 0.089 mm)
Roll paper core
inside diameter 7/16 inch or more
2
Ribbon must be from an approved manufacturer and tested with a rolling ASCII test pattern using 15 cpi in HSD
mode.
Summary of Contents for Ithaca 90PLUS Series
Page 2: ...Page ii Rev Q 11 07 05...
Page 12: ......
