Section 2: Installation
Operator Manual
Doc. No. 101205
2.2
Step 6
Using the supplied combination (factory preset at 50-25-50), open the security Door.
This combination should be changed as soon as possible. Refer to page 4.5 (dial) or
4.7 (electronic) for instructions on opening or changing the lock.
Step 7
After the anchor nuts are in place, according to the anchor holes on the bottom of
the Mini-Bank, secure the anchor bolts snugly. Do not over tighten anchors as it
may distort the vault and cause problems with the door linkage.
END
2.1.3 HARDWARE SETUP
Step 1
Verify the power voltage (115/220V) to be used and set the
appropriate voltage on the power supply. Default will be
115V. The default setting should be 115V
Step 2
Verify that the telephone line to be used for the ATM is in proper working order.
Tranax recommends the use of shielded (CAT5) phone line in locations with close
proximity to other appliances.
Step 3
Open the security door and remove any shipping materials and note any warning or
installation instructions. See page 4.1 for assistance.
Step 4
Remove the cash cassette from the box (removable cassette dispensers only). Fill
the cassette or cash drawer with the appropriate amount of notes, and carefully
place it in the Cash Dispensing Unit. Place the appropriate denomination label on the
front of the cassette. See page 4.9 for instruction.
Step 5
Before closing the vault, thoroughly test the combination lock by locking and
unlocking the lock several times. It is much easier to diagnose potential lock
problems before shutting the door.
