TP-Link JetStream T2600G-28TS, User Manual

Page: 1018 / 1136

Configuring OAM Ethernet OAM Configurations
User Guide 989
■ Configuring Error Frame Event
An Error Frame event occurs if the number of frame errors exceeds the defined threshold
within a specific period of time.
Follow these steps to configure the Error Frame event:
Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
Step 3 ethernet-oam link-monitor frame [ threshold threshold ] [ window window ] [ notify {disable
| enable}]
Configure the relevant parameters of Error Frame event.
threshold : Specify the threshold of received frame errors within a specific period of time.
Valid values are from 1 to 4294967295, and the default value is 1.
window : Specify the time period in units of 100ms (for example, 2 refers to 200ms), in which
if the number of received errors exceeds the threshold, a link event will be generated. Valid
values are from 10*100 to 600*100 ms, and the default value is 10*100 ms.
disable | enable: Enable or disable notifications to report the link event. By default, it is
enabled.
Step 4 show ethernet-oam configuration [ interface fastEthernet { port | port-list } | interface
gigabitEthernet { port | port-list } | ten-gigabitEthernet { port | port-list } ]
Verify the OAM configuration.
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to enable Error Frame notification and configure the
threshold as 1 and the window as 2000 ms (20*100 ms) on port 1/0/1:
Switch#configure
Switch(config)#interface gigabitEthernet
1/0/1
Switch(config-if)#ethernet-oam link-monitor frame threshold 1 window 20 notify
enable
Switch(config-if)#show ethernet-oam configuration interface gigabitEthernet 1/0/1