2-11
Solar Panel Installation, Cont.
Procedure
Our standard solar panel must be mounted within 12 feet of XRC. For
Solar Panel mounting, the following materials are required.
In the following procedure, the common name for a component, its
jumper number if available (Abbreviated J) or part is followed by a
number in parentheses. For a complete overview of the XRC-195 board,
see Figure 1–5.
Instructions
Step Procedure
1.
Attach 2” pipe coupling to top end of XRC 40” mounting pipe.
Securely tighten.
2.
Install 2” pipe extension into coupling and securely tighten.
3.
Before installation of the panel, check solar panel using digital
voltmeter to verify polarity and output voltage. Voltage will
vary depending on amount of sun, angle to sun, etc
4.
Install Solar Panel on mounting bracket, if required, with
provided hardware. Install Solar Panel Cable if required.
DO NOT connect other end of Solar Panel Cable to XRC until instructed
to do so.
5.
Attach Solar Panel mounting plate to top end of 2” extension
pipe with U-bolts and associated mounting hardware. Do not
tighten U-bolts until Solar Panel has been correctly orientated.
6.
For northern hemispheres, position Solar Panel facing south.
For southern hemispheres, position Solar Panel facing north.
For optimum charging, solar panel should not be in shadows
for the majority of the day. Panel should be kept clean for
maximum charging.
7.
Remove CHGR Input terminal block (J17) from Digital Board.
Insert Solar Panel power cable through an access hole on
side of case. Allow enough power cable for field wiring to
CHGR Input +/- terminations on J17.
8.
Before making connections to terminal block, trim wire ends
back 1/4”. Loosen terminal block securing screws, insert wire
then retighten. Connect Solar Panel (+) lead to (+) terminal
and (-) wire to (-) terminal. Verify main battery pack is
connected and then reinstall terminal block with wires
attached.
9.
Following connection of Solar Panel power cable, secure
cable to 2’ extension pipe and mounting pipe cable with plastic
tie-wraps provided.
Summary of Contents for XRC6490
