Toshiba T-Series T2200sx, User Manual

Page: 90 / 230

4-8
6. Enter the desired subtest number from the subtest menu and press
Enter
. The following
message will appear.
TEST LOOP (1:YES/2:NO) ?
Selecting
YES
increases the pass counter by one each time the test cycle ends and then re-
starts the test cycle.
Selecting
NO
returns you to the subtest menu after the test is completed.
7. Type in 1 or 2 for the Test Loop and press
Enter
. The following message will appear.
ERROR STOP (1:YES/2:NO) ?
Selecting
YES
stops the test program when an error is found and displays the operation guide
on the right side of the display screen as shown below.
ERROR STATUS NAME [[ HALT OPERATION ]]
1: Test End
2: Continue
3: Retry
1:
Terminates the test program execution and exits to the subtest menu.
2:
Continues the test.
3:
Restarts the test from the beginning of the test.
Selecting
NO
displays the error status, increases the error counter by one, and resumes the
test.
8. Type in 1 or 2 for the Error stop and press
Enter
to execute the subtest chosen from the
subtest menu. Table 4-1 in Section 4.3 lists the subtests available for each test on the DIAG-
NOSTIC TEST MENU.
Table 4-3 in Section 4.14 describes the error codes and error status for each error.