H9 ASD Installation and Operation Manual
77
Command Mode
Program
⇒
Fundamental
⇒
Standard Mode Selection
The Command Mode Selection establishes the source of the command input
for the ASD. Command inputs include Run, Stop, Forward, etc. The Override
feature may supersede the Command Mode Selection setting (see
Command
Mode and Frequency Mode Control on pg. 36
).
Settings:
0 — Terminal Block
1 — Not Used
2 — EOI Keypad
3 — RS485
4 — Communication Option Board
Direct Access Number — F003
Parameter Type — Selection List
Factory Default — Terminal Block
Changeable During Run — No
Frequency Mode 1
Program
⇒
Fundamental
⇒
Standard Mode Selection
The Frequency Mode 1 setting establishes the source of the frequency-control
input for the ASD. The Frequency Mode 2 setting or the Override feature may
supersede the Frequency Mode 1 setting (see
Command Mode and Frequency
Mode Control on pg. 36
and
F200
for more information on this setting).
Note:
Only Bolded items from the Settings list below may be placed in
the Override mode. See the section titled
Command Mode and
Frequency Mode Control on pg. 36
for more information on the
Override feature.
Settings:
1 — V/I
2 — RR
3 — RX
5 — EOI Keypad
6 — RS485
7 — Communication Option Board
8 — RX2 Option (AI1)
9 — Option V/I
10 — UP/DOWN Frequency
11 — Pulse Input (option)
12 — Pulse Input (motor CPU)
13 — Binary/BCD Input (option)
Direct Access Number — F004
Parameter Type — Selection List
Factory Default — RR
Changeable During Run — No
F003
F004
