H9 ASD Installation and Operation Manual
3
Equipment Inspection
•
Upon receipt of the equipment inspect the packaging and equipment for shipping damage.
•
Carefully unpack the equipment and check for parts that were damaged during shipping, missing
parts, or concealed damage. If any discrepancies are discovered, it should be noted with the carrier
prior to accepting the shipment, if possible. File a claim with the carrier if necessary and
immediately notify your Toshiba sales representative.
•
DO NOT install or energize equipment that has been damaged. Damaged equipment may fail
during operation resulting in equipment damage or personal injury.
•
Check to see that the rated capacity and the model number specified on the nameplate conform to
the order specifications.
•
Modification of this equipment is dangerous and should only be performed by factory trained
representatives. When modifications are required contact your Toshiba sales
representative.Inspections may be required before and after moving installed equipment.
•
Inspections may be required before and after moving installed equipment.
•
Keep the equipment in an upright position.
•
Contact your Toshiba sales representative to report discrepancies or for assistance if required.
Handling and Storage
•
Use proper lifting techniques when moving the H9 ASD; including properly sizing up the load,
getting assistance, and using a forklift if required.
•
Store in a well-ventilated covered location and preferably in the original carton if the equipment
will not be used upon receipt.
•
Store in a cool, clean, and dry location. Avoid storage locations with extreme temperatures, rapid
temperature changes, high humidity, moisture, dust, corrosive gases, or metal particles.
•
The storage temperature range of the H9 ASD is -13° to 158° F (-9.4° to 70° C).
•
Do not store the unit in places that are exposed to outside weather conditions (i.e., wind, rain, snow,
etc.).
•
Store in an upright position.
Disposal
Never dispose of electrical components via incineration. Contact your state environmental agency for
details on disposal of electrical components and packaging in your area.
