Toshiba e-STUDIO165, Service Manual

Page: 156 / 313

e-STUDIO165/167/205/207/237 © 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 18
[G] Bottom margin
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. (Adjustment Mode)
(2) Press [4] [FAX] [PAPER FEED] (Select from 0: bypass, 1: drawer, 2: PFU, 3: PFP upper
drawer or 4: PFP lower drawer.) [START] (A solid black pattern (whole area) is printed out.
Print out 2 sheets in A3/LD size.).
(3) Place the paper printed out in step (2) to cover the whole area of the original glass.
(4) Press the [INTERRUPT] button to enter the normal mode.
(5) Make a copy at the mode of A3/LD, 100%, Text/Photo and standard drawer of the equipment.
(6) Press the [INTERRUPT] button to enter the adjustment mode.
(7) Measure the blank area G at the trailing edge of the copied image.
(8) Check if the blank area G is within the range of 2±1.0 mm.
(9) If not, use the following procedure to change values and repeat the steps (4) to (8) above.
(Adjustment Mode) (Key in the code [433]) [ENTER]
(Key in a value (acceptable values: 0 to 255))
Press the [ENTER] button (stored in memory). [CANCEL] (“MC” is displayed.)
* The larger the adjustment value is, the wider the blank area at the trailing edge becomes
(approx. 0.04 mm/step).
Fig. 3-14
G
Feeding direction
06/04