Toshiba e-STUDIO165, Service Manual

Page: 136 / 313

e-STUDIO165/167/205/207/237 © 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 114
RAM clear table
*1: When RAM clear is performed, no message is indicated on the LCD.
Once RAM clear has been completed, “Please wait” appears on the LCD.
Note: Note:
In the equipment with the Scanner Upgrade Kit (GA-1200) installed, do not turn the power OFF
within one minute after the message is changed from "Please wait" to "READY" when the RAM
clear is started by turning the power ON while pressing [1], [3] and [*] simultaneously.
*2: RAM clear may take more than 10 seconds. Note that the error (Broken Registration) results if the
power is turned off during RAM clear.
*3: When the TELBOOK board of the external keyboard (GJ-1040) has been installed, clear its RAM.
*4: Counter values and Process values of the 08 codes are not reset.
*a: Total Scan, Print jam, Job counter, Counter for each paper size
*b: Total Print, Drum counter, Toner counter, etc.
*c: One touch, Speed, Group etc.
*d: Polling Password
[1]+[3]+[*]+
[POWER]
*1.2
[1]+[3]+[#]+
[POWER]
*1
[*]+[#]+
[POWER]
*1
[START]+
[STOP]+
[POWER]
*1
[0]+ [2]+
[POWER]
[1]+[2]+[*]+
[POWER]
*3
FUNC/SYSFUNC/
UAD etc.
Set default
value
Set default
value
Set default
value
Adjustment mode (05)
Setting mode (08)
Set default
value
*4
Set default
value
*4
Set default
value
*4
Journal report data Clear Clear Clear
Error data on FAX
communication
Clear Clear Clear
Protocol trace data Clear Clear Clear Clear Clear
Counter data
*a
Clear
Drum related data
*b
Dial data
*c
Clear Clear Clear
One touch data Clear Clear Clear
Department code data Clear Clear
Secure receive data Clear Clear
Station name Clear Clear
ID number Clear Clear
Password
*d
Clear Clear
Pending FAX job data Clear Clear Clear
Stored JOB data Clear Clear Clear