Toshiba e-studio 151, Service Manual

Page: 84 / 176

e-STUDIO162/162D/151/151D TEST COMMAND, TROUBLE CODES 10 - 15
26 43 Side void amount setting
(SIDE VOID) [Function]
When this test command is executed, the currently set code of the side void quantity is displayed (ini-
tial display), and the set data are saved. (Setting range: 0 – 10, Default: 4 (= One side 2.0mm))
∗
When the adjustment value is increased by 1, the side void is changed as follows:
Side void adjustment: The side void is increased by 0.5mm. (The side void of “Set value x 0.5mm”
is made.)
[Operation]
62 Energy-save mode copy
lamp setting (C-LAMP E-S) [Function]
Used to set half-ON /OFF of the copy lamp in the pre-heat mode.
When this test command is executed, the current set code number is displayed. Enter the desired
code number and press [OK (ENTER)/START] key to save the setting.
[Operation]
The operation is similar to test command 21-01.
30 01 Paper sensor status display
(P-SENSOR) [Function]
The paper sensor status is displayed on the LCD.
∗
Since the manual paper feed sensor is a single bypass sensor, its status is not displayed.
∗
The width sensor is available only in the FAX models.
[Operation]
Main
code Sub
code
Contents Details of function/operation
9
Code Setting Remark
0 0 mm
1 0.5 mm
2 1.0 mm
3 1.5 mm
4 2.0 mm Default
5 2.5 mm
6 3.0 mm
7 3.5 mm
8 4.0 mm
9 4.5 mm
10 5.5 mm
1) Initial display 2) [10KEY] 3) [OK (ENTER)/START]
26-43 SIDE VOID
4( 0-10)
26-43 SIDE VOID
5( 0-10)
26-43 SIDE VOID
5( 0-10)
Code number Setting Display item Remark
0 Copy lamp OFF OFF
1 Copy lamp half-ON ON Default
Sensor Display item Remark
Paper exit sensor POD
No. 1 tray paper width sensor PD1
Paper entry sensor PPD1
Duplex sensor PPD2
No. 2 tray paper feed sensor PPD3
New drum cartridge sensor DRST
1) Initial display 2) When sensor ON
30-01 P-SENSOR 30-01 POD PD1 PD2
PPD1 PPD2 PPD3 DRST
e-STUDIO162_151.book 15 ページ ２００４年１２月２日 木曜日 午後９時３７分