e-STUDIO162/162D/151/151D TEST COMMAND, TROUBLE CODES 10 - 12
24
09
Printer counter clear
(PRT.CLR.)
[Function]
When [OK (ENTER)/START] key is pressed, the printer counter value is cleared to 0, and "000,000" is
displayed on the LCD.
[Operation]
10
FAX counter clear (FAX
CLR.) (Executable only
when the FAX is installed.)
[Function]
When PRINT switch is pressed, the FAX count value is set to 0 and "000,000" is displayed on the
LCD.
[Operation]
13
Scanner counter clear
(SCAN CLR.)
[Function]
When [OK (ENTER)/START] key is pressed, the scanner counter value is cleared to 0, and "000,000"
is displayed on the LCD.
[Operation]
14
ADF JAM total counter clear
(S JAM TTL CLR.) (Disabled
when set to OC) (Executable
only when the ADF is
installed.)
[Function]
When [OK (ENTER)/START] key is pressed, the ADF JAM total counter value is cleared to 0, and
"000,000" is displayed on the LCD.
[Operation]
15
Scanner mode counter clear
(S-MODE CLR.)
[Function]
When [OK (ENTER)/START] key is pressed, the scanner mode counter value is cleared to 0, and
"000,000" is displayed on the LCD.
[Operation]
25
01
Main motor operation check
(MAIN MOTOR CHK)
[Function]
When [OK (ENTER)/START] key is pressed, the main motor (and the duplex motor in the case of a
duplex model) is operated for 30sec.
To reduce toner consumption, if the developing unit is installed, the developing bias, the main
charger, and the grid are also outputted.
In this case, laser discharge is required when stopping the motor, the polygon motor is also operated
at the same time. Check for installation of the developing unit. If it is not installed, the high voltage
above is not outputted and only the motor is rotated.
To check the developing bias, install the developing unit.
After completion of 30sec operation, the machine goes into the sub code entry standby mode.
[Operation]
10
Polygon motor operation
check (LSU CHK)
[Function]
When [OK (ENTER)/START] key is pressed, the Bios is called to rotate the polygon motor for 30sec.
After completion of 30sec operation, the operation is turned off with the Bios and the machine goes
into the sub code entry standby mode.
[Operation]
Main
code
Sub
code
Contents
Details of function/operation
1) Initial display
24-09 PRT.CLR.
CLEARED 000,000
1) Initial display
24-10 FAX CLR.
CLEARED 000,000
1) Initial display
24-13 SCAN CLR.
CLEARED 000,000
1) Initial display
24-14 S JAM TTL CLR.
CLEARED 000,000
1) Initial display
24-15 S-MODE CLR.
CLEARED 000,000
1) Initial display
25-01 MAIN MOTOR CHK
EXECUTING...
1) Initial display
25-10 LSU CHK
EXECUTING...
e-STUDIO162_151.book 12
ページ
2004年12月2日 木曜日 午後9時37分
Summary of Contents for e-studio 151
Page 170: ...Memo ...
Page 171: ...Memo ...
Page 172: ...Memo ...
Page 176: ...2 17 2 HIGASHIGOTANDA SHINAGAWA KU TOKYO 141 8664 JAPAN ...