Toro Multi Pro WM, Operator'S Manual

Page: 88 / 96

Installing the Jackstands
Lifting equipment capacity: 408 kg (900 lb)
1. Align the front jackstand with the jackstand
receiver at the front of the tank (
Figure 130 ).
g028422
Figure 130
1. Clevis pin (1/2 x 3 inch) 4. Hairpin (5/32 x 2-5/8
inches)
2. Jackstand receiver 5. Front jackstand
3. Lock knob
2. Insert the jackstand into the receiver until the
middle hole in the horizontal jackstand tube is
aligned with the hole in the top of the receiver
(
Figure 130 ).
3. Insert the clevis pin (1/2 x 3 inches) into the
holes in the jackstand and receiver and secure
the clevis pin with a hairpin (5/32 x 2-5/8 inches).
4. Thread a lock knob into the receiver and tighten
the knob by hand (
Figure 130 ).
5. Align the rear jackstand with the rear jackstand
receiver (
Figure 131 ).
g028423
Figure 131
1. Hairpin (5/32 x 2-5/8
inches) 3. Jackstand receiver
2. Clevis pin (1/2 x 4-1/2
inches)
4. Rear jackstand
6. Align the hole in the top of the jackstand with the
hole in the frame of the tank skid (
Figure 131 )
7. Secure the jackstand to the receiver and the
frame with 2 clevis pins (1/2 x 4-1/2 inches) and
2 hairpins (5/32 x 2-5/8 inches) as shown in
Figure 131 .
8. Repeat steps 1 through 7 for the front and rear
jackstands at the other side of the tank skid.
88