CAUTION
If you leave the key in the starter switch, someone could accidently start the engine and
seriously injure you or bystanders.
Remove the key from the starter switch and disconnect the negative battery cable from
the battery before you do any maintenance. Set the battery cable aside so that it does not
accidentally contact the battery post.
Pre-Maintenance
Procedures
Accessing the Machine
Raising the Tank Assembly
DANGER
The sprayer tank assembly represents a
stored energy hazard. If not properly retained
when installing or removing the assembly,
it can move or fall and injure you or other
bystanders.
Use straps and an overhead lift to support
the sprayer tank assembly during installation,
removal, or any maintenance whenever you
remove the retaining fasteners.
You can raise up the tank assembly to access to the
engine and other internal components. Pivot the boom
extension forward to distribute the weight more evenly.
1.
Empty the spray tank.
2.
Park the vehicle on a level surface.
3.
Use the boom-control switches to raise the
boom extension to approximately 45°.
4.
Engage the parking brake, shut off the engine,
and remove the key.
5.
Remove the safety bolts from the front of the
skid (
g022366
Figure 96
1.
Bolt (1/2 x 1-1/2 inches)
2.
Locknut (1/2 inch)
6.
Fold the boom extensions forward, alongside
the tank assembly to distribute the weight more
evenly, and keep it from tipping backward.
7.
Raise the tank assembly until the lift cylinders
are fully extended.
8.
Remove the bed support from the storage
brackets at back of the ROPS panel (
).
g002397
Figure 97
1.
Bed support
9.
Push the bed support onto the cylinder rod,
making sure that the support end tabs rest on
69
Summary of Contents for Multi Pro WM
Page 91: ...Schematics g209531 Flow Diagram Sprayer System Rev B 91...
Page 92: ...Notes...
Page 93: ...Notes...
Page 94: ...Notes...
