Toro 44225, Operator'S Manual

Page: 24 / 32

5. Pivot the hopper rearward and lean it against
a wall, ladder, etc. Do not allow the hopper to
rest against the rear of machine, as damage
may result to the brush or the hydraulic couplers
(
Figure 33 ).
Important:
Ensure that the hopper is
pivoted beyond center and/or secured to a
wall or post to prevent it from accidentally
falling on the work area (
Figure 33 ).
g011388
Figure 33
6. Loosen 2 cap screws, washers, and nuts on the
right side of machine, securing the slider bed to
the frame (
Figure 34 ). Ensure that the fasteners
are loose enough to allow the slider bed to be
tipped.
g011417
Figure 34
1. Slider bed mounting cap screws
7. Remove 2 cap screws, washers, and nuts on
the left side of the machine, securing the slider
bed to the frame (
Figure 35 ).
g011418
Figure 35
1. Lift bar 2. Slider bed mounting cap
screws
8. Remove the belt as follows:
A. Cut the belt and remove it from the rollers.
or
B. Insert a plastic belt tool between each roller
and the belt. Rotate the rollers until each
tool is positioned to the outside of each
roller. The tool must be inserted past the rib
in the center of the belt.
C. Insert a lift bar into hole on left side of
machine.
D. Raise the lift bar to tip the slider bed.
E. Slide the belt and belt tools off the rollers at
the same time.
9. Install the belt as follows:
A. Insert a lift bar into hole on left side of
machine and raise lift bar to tip slider bed
(
Figure 35 ).
B. Install the belt onto rollers as far as possible.
C. Insert a plastic belt tool between each roller
and belt. Rotate rollers until each tool is
positioned to the outside of each roller. The
tool must be inserted past the rib in the
center of the belt.
D. Slide the belt and belt tools onto rollers until
the belt is approximately centered on the
rollers.
E. Remove the belt tools from between the
belt and the rollers.
F. Position belt so rib fits into alignment
grooves in each roller.
G. Reverse the procedure to assemble the
hopper and the chain components.
H. Adjust the belt. Refer to Adjusting the
Conveyor Belt (page 22) .
24