Toro 44225, Operator'S Manual

Page: 10 / 32

3
Connecting the Lift
Cylinders
Parts needed for this procedure:
2 Cylinder pin
2 Cap screw (1/4 x 3/4 inch)
2 Locknut (1/4 inch)
Procedure
1. Secure each lift cylinder rod end to topdresser
base with a cylinder pin (
Figure 11 ).
2. Secure each cylinder pin to the topdresser base
with a cap screw (1/4 x 3/4 inch), a flat washer,
and a nut (
Figure 11 ).
g011402
Figure 11
1. Cylinder rod 2. Cylinder pin
Important:
Always unlock the dump stop
lever before attempting to attach the cylinder
for tilting. Use the tilt of the cylinders only
for service of the engine or hydraulics
underneath.
WARNING
Failure to properly support the
topdresser when performing service
could result in serious personal injury.
Do not rely on the cylinders to hold up
the machine. Block the topdresser up
before going underneath to perform any
type of service.
Important:
On vehicles with serial numbers 240000001
and up, the bed or topdresser cannot be
raised unless the lift cylinder hoses are
connected to the vehicle.
CAUTION
Failure to follow the proper procedures for
tilting the hopper of the topdresser could
cause serious injury.
Remove the front mounting bolts before tilting
the hopper.
Tilt the hopper only when the hopper is empty.
4
Using the Bed Support
Parts needed for this procedure:
–
Bed support (supplied with Workman vehicle)
Procedure
Important:
Always install or remove the bed
support from the outside of the bed.
1. Raise the bed until the lift cylinders are fully
extended.
2. Remove the bed support from the storage
brackets on the back of the ROPS panel (
Figure
12 ).
10