Toro 44225, Operator'S Manual

Page: 12 / 32

g009822
Figure 16
1. Quick coupler A position 2. Quick coupler B position
3. Clean any dirt from the topdresser quick
couplers (
Figure 17 ) before connecting them.
Dirty couplers can introduce contamination to
the system. After cleaning, attach both quick
couplers to the Workman. The hoses are
marked “A” and “B”, match them to the quick
couplers when installing. Ensure that both quick
couplers are full engaged.
Note:
The couplers shown in Figure 17 are from
vehicles with serial numbers prior to 239999999.
g011403
Figure 17
1. Quick coupler A position 2. Quick coupler B position
Important:
The Workman hydraulic
system operates on Dexron III automatic
transmission fluid. This fluid provides gear
and bearing lubrication as well as fluid for
operating the hydraulic system.
When the remote hydraulic system quick
couplers are connected, hydraulic fluid
flows from the machine to the vehicle. If
the hydraulic fluid in the machine is not
the same or equivalent to the fluid in the
vehicle, component damage to the transaxle
or hydraulic system may result.
Check for fluid compatibility and take
appropriate action if the machine is
subsequently used in conjunction with any
other product using fluids other than Dexron
III ATF.
WARNING
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury.
• Seek immediate medical attention if
fluid is injected into skin. Injected
fluid must be surgically removed
within a few hours by a doctor.
• Ensure that all hydraulic-fluid hoses
and lines are in good condition and all
hydraulic connections and fittings are
tight before applying pressure to the
hydraulic system.
• Keep your body and hands away from
pin-hole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find
hydraulic leaks.
• Safely relieve all pressure in the
hydraulic system before performing
any work on the hydraulic system.
Important:
Check the hydraulic fluid
level after installation of the topdresser.
Check the operation of the topdresser, then
check the level of the hydraulic fluid again.
Operation of a vehicle with low fluid level can
damage the pump, remote hydraulics, power
steering, and vehicle transaxle. Use Dexron
III automatic transmission fluid if additional
fluid is needed.
4. Start the vehicle engine and test the rotation
of the conveyor and the brush. Place the
remote hydraulics lever of the vehicle in the
RUN
position. The rotation should be as shown in
Figure 18 . If the rotation is backwards the quick
couplers need to be reversed.
g011387
Figure 18
12