Menu: Subscriber
101
Position message
After the welcome message the caller is transferred to the holding loop. This collects
all calls and if possible transfers them to the desired target. During this time the caller
is informed of the automatically generated position number. Press the 0 button to go
back to the welcome message.
Note:
The announcement of the queue position can be deactivated.
Enter targets
You state here the target that is to be connected for each number button.
Allocation for incoming external calls
Here you can set via which external MSNs or DDIs the subscriber can be called.
Simply select the desired MSNs in the displayed table.
Greeting and transfer
The greeting and transfer function transfers the caller directly to the connection tar-
get. During the signal the caller hears the welcome message. If the target is engaged
the caller is played the position message until they are connected.
Remark: To avoid pending calls the pabx disconnects incomming external calls
via analogue ports automatically after one minute in some cases, e.g. in
idle state or if the called target does not pick up the phone.
Settings
WT selection
The greeting and transfer can be entered in several ways. This gives you the option
of entering a greeting and transfer for several external MSNs.
Greeting and transfer (function)
The selected greeting and transfer is activated via this button
Select language
The position is announced in the holding loop depending on the position. You stipu-
late the language for the position here.
Maximum memory for OGM
Your voicemail system has a recording capacity between 3 and up to 15 hours for
announcements and messages. The desired capacity for announcements should be
assigned to the function „greeting and transfer“ here.