MU-iCAT-1120
iCAT
29 - 40
b1
b2
a
b
a
To wash the tank circuit, perform the following steps:
- make sure the circuit washing tank is full;
- empty the remaining liquid from the tank through the drain
valve (a), taking care to collect it in cans and to dispose of in
accordance with the legal provisions in force;
- close the drain valve (a);
- move the three-way valve lever to the "WASH" position (b1);
- the circuit will be cleaned by the clean water of the circuit
cleaning tank;
- if you want to clean the cannon nozzles leave the 3-way valve
in the “WASH” position and run the cannon, making sure it is
directed at already-treated areas as the water exiting the
cannon contains mixtures residue;
- empty the remaining liquid from the tank through the drain
cap (a), taking care to collect it in cans and to dispose of it in
accordance with the legal provisions in force;
- return the three-way valve to the "SPRAY" position (b2);
- fill the circuit washing tank.
6.3.3
Circuit washing
6.3.2
Cleaning the lance
ATTENTION: If, at the end of the spraying, a huge amount of liquid has remained inside the tank, drain the tank
and collect the liquid in cans and dispose of according to the provisions of law in force or use up the content by
spraying on an area already sprayed.
ATTENTION: If the tank is not completely empty and still contains the mixture, you should leave the lever of the
three-way valve in "WASH" position up to the next use of the product; that is to avoid it enters the pump suction
circuit when the equipment is unused.
Failure to accurately wash the pump and tank circuit after each use shortens the life of the machine and VOIDS
ANY WARRANTY.
Cleaning the lance requires a large amount of water because the
lance hose is very long and there is not enough water in the
wash tank:
- fill the tank half-way with clean water;
- switch on the engine and regulate pressure to 25-30bar;
- open the lance valve (a);
- operate the lance for several minutes, making sure you spray
areas already treated in that the hose and the lance itself may
still contain mixtures residues;
- return pressure to minimum;
- close valve (a);
- switch off engine.
