Chapter 4: Using the web interface
98-129217-A
Setting up the interfaces
78
Configuring the I/O interface
To configure the I/O pins, do as follows:
1.
Select
SETTINGS
> Discrete I/O
.
2.
For each pin you want to use, select
Enabled
.
3.
For each pin, select the function of the pin. Refer to the previous section,
4.
If you are using the Ignition function and you want the terminal to stay on for a few minutes
after the Ignition is switched off, enter the number of minutes under
DELAYED SHUTDOWN
.
For further information on the Ignition function, see
5.
If you are using a ringer output, select the incoming call types that should activate the ringer
under
RINGER OUTPUT
.
6.
If you are using a Mute output, select the incoming call types that should activate the Mute
function under
MUTE OUTPUT
.
7.
Click
Apply
.
