Thomson Neff WIESEL POWERLine WM120, Mounting And Maintenance Instructions

Page: 64 / 148

Maintenance 0 8/41
Sizes WM/WV60, 80 and 120
1.
Fig. 17:
Remove the fastening screws from the sliding carriage and carefully lift the
complete carriage off vertically.
Attention
: Ensure that the strip holders remain lying on
the tubular profile!
2. Push the new cover strip through both strip holders (at the first one, diagonally up from
below, at the second diagonally down from above).
3. Fasten the cover strip in the fixed-bearing housing with the tension plate and the
threaded studs.
4. Clip the cover strip into the tubular section in front of and behind the adapter.
5. Shift the strip holders until they sit close to the end of the adapter, and align them on the
tubular section so as to allow for a centred run of the strip through the holders
6. Carefully lower the sliding carriage vertically onto the adapter and fasten it (for the
tightening torque of the screws, see the table in Chapter 10 "Technical Data").
Take care not to displace the holders, and that the threaded studs of the carriage sit
exactly in the respective holes in the strip holders.
7. Mount the leaf spring and spring holder in the cover plate.
The leaf spring must be installed so that it is bent backwards!
8. At the end next to the movable bearing, push the end of the cover strip through the cover
plate, and at the same time clip it into the tubular section, beginning at the sliding
carriage.
9. The overlapping end of the cover strip may be cut off.
Fig. 17: Replacing the cover strip
9 Removal/Dismantling
Linear drive units may be removed only when the machine is switched off and by
trained personnel. Proceed in the reverse sequence as described in chapter 4
"Mounting a linear drive unit". Pay particular attention to the safety notices in this
chapter.
62 WIESEL POWER Line
®