Thomson Neff WIESEL POWERLine WM120, Mounting And Maintenance Instructions

Page: 63 / 148

0 8/41 Maintenance
8.3.2 Worn out cover strip no longer in place
Size WM40
1.
Fig. 16:
Remove both scraper brushes.
2. Loosen threaded studs of the two outer strip holding rollers.
3. Press the cylindrical pins out of the outer holding rollers.
4. Remove strip holding rollers.
5. Push cover strip through sliding carriage.
6. Fasten the cover strip in the fixed-bearing housing, using the tension plate and threaded
studs.
7. Clip the cover strip into the tubular section up to the sliding carriage.
8. Insert the front strip holding roller into the sliding carriage.
9. Push the cylindrical pin through the front strip holding roller.
10. Screw in threaded studs until cylindrical pin is fixed crosswise and the cover strip under
it is completely clipped into the tubular section.
11. Clip the cover strip into the tubular section behind the sliding carriage and up to the
cover plate.
12. Insert the rear strip holding roller into the sliding carriage.
13. Push cylindrical pin through strip holding roller.
14. Screw in threaded studs until cylindrical pin is fixed crosswise and the cover strip under
it is completely clipped into the tubular section.
15. Cut off cover strip, leaving an overlap of 6-7 mm (depth of pocket in cover plate is
8 mm).
16. Fasten the cover strip in the end plate, using the tension plate and threaded studs.
17. Replace the scraper brushes.
Fig. 16: Replacing the cover strip
WIESEL POWER Line
®
61