Thermo Scientific Ramsey MINI CK100, Operating And Service Manual

Page: 48 / 97

3-18
3.8.3 Linearization
Manual linearization can be accomplished by applying a known test weight(s) or loading the bin
with pre-weighed material and calculation the scale error.
Press CHOICE for selections, YES to enable, or NO to disable linearization. Once enabled,
no linearization is done until the operator manually enters the linearization factors.
Default: No Selezioni : Yes, No
The linearization factors can be entered with the following screens.
If you enter 1.000 (default value), the load will not be corrected in that portion of the range. A
number lower than 1.000 will reduce the span, while a number larger than 1.000 will increase
the span.
Factor: Default: 1.000 Min: 0.500 Max: 1.500
Then to insert the weight values and corresponding factors, until 5 different points.
(Pressing ACQ for acquired actual weight value). Then to insert until 5 points.
3.9 Setup and Configuration Menu
The following menu, from MENU 2 to MENU 5 are used for SETUP , CONFIGURATION
and DIAGNOSTIC of the system.
For MENU 2 selection press SETUP key then ARROW DOWN until the screen MAIN MENU
2 . The submenu available are:
•
Display
•
Scale Data
•
Calibrazione Data
- LINEARIZ. 1 -
Linearization
NO
CHOICE ENTER
Password:Service
- LINEARIZATION #1 -
Weight 0,0 kg
Fact. 1,000000
ENTER ACQ FACTOR
Password:Service