Thermo Scientific Orion Star
™
and Star Plus Meter User Guide
EN-80
Pausing the Autosampler
To pause the autosampler during operation, press
. To resume operation, press
again .
Stopping the Autosampler
To stop the autosampler during operation and abort the run, press and hold
for about 3 seconds .
Moving the Electrode Arm
At the end of a run, when the electrode arm
has returned to home position and is lowered
into beaker one, press
to lift the electrode
arm and press
again to lower the electrode
arm . See the diagram to the right . This action
is operational only when the autosampler is
not running and the electrode arm is in the
home position .
Turning Off the Autosampler Function
To disable the autosampler, press
in the measurement mode to enter the
setup menu . Press
until
is displayed on top line . Press
until the
arrow icon points to the middle line and press
until
is displayed . Press
until the arrow icon points to the bottom line and press
until
is
displayed . Press
until the arrow icon points to the top line . Press
to return
to measurement mode .
Autosampler Dip Switch Settings
The dip switch cover is located on
the rear panel of the autosampler and
a small Phillips head screw driver is
needed to remove the dip switch cover .
The ON position for the dip switches is
down and the OFF position is up . To set
the autosampler dip switches to 9600
for Com 1, adjust DIP switch 4 and DIP
switch 5 to the OFF position (up) .
DIP 1
DIP 2
DIP 3
DIP 4
DIP 5
Even Parity
ON
No Parity
OFF
9600 Baud
OFF
OFF
1200 Baud
ON
OFF
2400 Baud
OFF
ON
38500 Baud
ON
ON
Orion Star Plus Benchtop Meter and Autosampler Interfacing
Summary of Contents for Orion Star
Page 367: ......
