Thermo Scientific Dionex AS-DV, Operator'S Manual

Page: 103 / 132

B • Installation
Doc. 065259-05 10/12
93
1. Connect the waste line:
a. Remove the 2-meter (78-inch) length of 0.76-mm (0.030-in) ID
green PEEK waste line (P/N 044777), the three double-cone
ferrules, and the three 10-32 fitting bolts from the Dionex AS-DV
Valve Kit.
b. Install a fitting and ferrule onto the end of the waste line. See
Section 5.1 for installation and tightening requirements.
c. Connect the waste line to the appropriate port on the valve:
For a 6-port injection valve, connect the waste line to port
2 .
For a 6-port bleed valve, connect the waste line to port
6 .
For a 10-port bleed valve, connect the waste line to port
8 .
d. Route the other end of the waste line to a waste container. Make
sure that the outlet of the waste line is below the level of the
Dionex AS-DV and is not elevated at any point.
2. Connect the Dionex AS-DV sample out line:
a. Install a fitting and ferrule onto the end of the Dionex AS-DV
sample out line.
b. Connect the sample out line to the appropriate port on the valve:
For a 6-port injection valve, connect the sample out line to port
3 .
For a 6-port bleed valve, connect the sample out line to port
5 .
For a 10-port bleed valve, connect the sample out line to port
7 .
3. Complete the plumbing for bleed valve operation:
Figure B-7. 10-Port Valve Plumbing for Bleed Valve
10
2
4
6
8
1
5
7
9
To Waste
To Injection Valve
Sample In Port
AS-DV Sample Out