2-13
Themis Computer
Installation and Operation
Installation Procedures
which can be “hot-swapped” in the field in the event of a fan failure.
2.1.6.1 Removing and Installing a 120-mm Fan
Perform the following steps to remove and install a 120-mm fan:
1.
On the top cover of the chassis, push the fan lid lock left to unlock the fan lid
(see
). Pull the fan lid upward exposing the two 120-mm fans.
2.
Each fan is secured by a locking latch on the left hand side. To remove a fan,
press the latch lock toward the center of the fan with the left hand index finger.
With the right hand index finger, press on the right hand side of the fan and
pull the fan directly upward from the RES-32XR3-S for X8DTL-6/6F chas-
sis.
3.
When the fan is removed, its 4-wire connector will automatically disconnect
from the chassis. Insert the replacement fan carefully into the empty fan slot
until it is flush with the second fan. The 4-wire connector will automatically
engage its counterpart connector successfully.
Note:
Since RES-32XR3-S for X8DTL-6/6F fans are “hot-swappable”, it is not
necessary to turn off system power in order to remove and replace a fan,
Figure 2-11.
The Dual RES-32XR3-S for X8DTL-6/6F 120-mm Fans
Hinged Fan Lid
120-mm Fan
120-mm Fan
Fan Lid Lock
Locking Stud (1 of 3)
Latch Lock
