Tetra Pak COMET RC, Manual

Page: 33 / 118

CRC804BF 6-8
Tetra Pak
Hoyer
6.2.9 Lid closing station
This station consists of a crimping tool (Pos. 1, Fig.
6.9) mounted on the up/down slide. Loosen screws
(Pos. 3/4, Fig. 6.9) to adjust height and centre
crimping tool over slot, tightening the screws again
afterwards.
Correct adjustment is important to make sure that
lids are closed properly.
Fig. 6.9
1
2
Fig. 6.10
6.2.10 Cone ejector station
This station is mounted underneath the lamellas. It is
controlled by a cam on the main shaft and supports
the pushers which eject the cones.
The upward movement allows the ejectors to lift
the cones from the slots, so that they are deposited
on the chute (Pos. 1, Fig. 6.10) by the ejector bend
(Pos. 2, Fig. 6.10).
The adjustment of the positions of the chute and
ejector bend is described in section 5.2,
Mechanical adjustment.
3
1
4
2