Tetra Pak COMET RC, Manual

Page: 23 / 118

CRC910BE 5-8
Tetra Pak
Hoyer
5.2.13 Cone ejector station adjustment
Adjust the positions of the ejector bends (Pos. 1,
Fig. 5.14) and the chute (Pos. 2, Fig. 5.14) so that
the cones do not interfere with these parts when
they are ejected.
The angle of the ejector bends (Pos. 1, Fig. 5.14)
can be adjusted by slackening the fixing screws (Pos.
3, Fig. 5.14) and correcting the positioning of the
cone on the chute.
Fig. 5.14
Fig. 5.15
5.2.14 Cup ejector station adjustment
Adjust the position of the ejector plates (Pos. 1,
Fig. 5.15) and chute (Pos. 2, Fig. 5.15) so that
when the cup is ejected it does not interfere with
these parts. If it does, slacken the fixing screws and
move the chute (Pos. 2, Fig. 5.15).
Check that the ejector plates (Pos. 1, Fig. 5.15)
push the cup onto the product conveyor chute (Pos.
2, Fig. 5.15).
5.2.12 Stamping station adjustment
The stamp is fixed to the raise/lower slide.
It can be centred over the lid by loosening the screw
(Pos. 1, Fig. 5.13); tighten the screw again when
finished.
Adjustment is important for correct stamping.
Fig. 5.13
2
1
1
2
3
1
2