Tetra Pak COMET RC, Manual

Page: 15 / 118

CRC804BD
4-3
Tetra Pak
Hoyer
Fig. 4.3
4.3 Transport and installation
4.3 Functional checks
Before starting up the machine, perform the following
control procedures:
a. Check that the emergency button is released
(Pos. 3, Fig. 4.3).
b. Turn on the main power switch (Pos. 6, Fig.
4.3).
c. Turn the switch (Pos. 4, Fig. 4.3) to start the
motor. Check that the table turns in the correct
direction (Pos. 5, Fig. 4.3). If not, invert the
phases.
Fig. 4.2
MODEL
SERIAL N.:
YEAR OF CONSTRUCTION:
ELECTRICAL SUPPLY:
PNEUMATIC SUPPLY:
REFRIGERANT:
HEATING GAS:
THERMAL CAPACITY:
kW
Kg.
Kcal/h
Via Monferrato, 52 - 20098 San Giuliano Milanese
( MI ) Italia - Tel. 02-982921 - Fax 02-9880171
Made in Italy
Tetra Pak
Hoyer
V
bar Nlt/min.
ph Hz
Type
1
4
3
1
5
6
F F F
The machine is assembled on wheels (Pos. 1, Fig.
4.3) so that it is easy for the operator to push it into
place.
a. Put the machine in position in the production
area, checking that there is sufficient space to
allow removal of the guards and ease of access
to internal machine parts.
b. Check the data shown on the plate to make sure
that the machine is compatible with the factory
power supply (Fig. 4.2).
c. The machine’s components are protected
electrically against short circuits (with
appropriate safety devices). Connect up the
electrical cable down-line of a master switch with
thermal overload cutout and ultrarapid fuses of
adequate amperage or an automatic
magnetothermal circuit breaker of adequate size.
d. Connect the compressed air supply to the
manifold and check that the pressure reducer is
set to 6 bar.
IMPORTANT:
Connections must be made only by skilled
technicians familiar with accident prevention
legislation.