Tetra Pak COMET RC, Manual

Page: 21 / 118

CRC910BE 5-6
Tetra Pak
Hoyer
5.2.8 Lid feed station adjustment
5.2.9 Cone lid closing station adjustment
Make sure that the lid feed station is switched off
(Pos. 15, Fig. 5.17) with the suction cups in the
raised position.
Check that the suction cups (Pos. 1, Fig. 5.9) are
in direct contact with the lids in the magazines. Adjust
height and centring over the slot by loosening the
screws (Pos. 1/2, Fig. 5.9) so as to raise the suction
cups (Pos. 1, Fig. 5.9) so that they are in direct
contact with the lids. Tighten the screws (Pos. 1/2, Fig. 5.9) when
finished.
With the machine at its slowest speed, check that
when the lid feed station is activated, the suction
cup mounting shaft drops down immediately after
the slotted disk has stopped, and then check that it
moves back up before the slotted disk is translated
again.
Check that the crimper (Pos. 1, Fig. 5.9) rests on
the outside of the slot (Pos. 2, Fig. 5.10) and
compresses the inner part of the lid in order to close
off the cone perfectly. Loosen the screws (Pos. 3/
Fig. 5.9
Fig. 5.10
4, Fig. 5.10) to adjust crimper height and centre it
over the slots, tightening the screws again when
finished.
2
1
3
3
1
4
2