TESVOLT TS25, Installation Manual

Page: 14 / 34

Step View
5
6
7
8
9
Insert the battery modules into the provided slide rails. From top to bottom.
Gently break out the intended breaking areas for the copper tracks at the
top of the cover (+). A combination drill can be used to help.
The cover is prepared for a re-assembly after uncovered passage for
the copper rails to be mounted.
Connect the DC copper rails, always bearing in mind that in the 48 V variation,
the positive pole must touch the positive pole and the negative pole must touch
the negative pole. Tighten the 13 mm screws using 12 nm of torque.
>>
Description/Note
12
www.tesvolt.com
Remove the side covers of the ABO from the battery module as follows:
1 = loosen the clamp
2 = pull slightly downwards
3 = over the outer wall of the cabinet
3
2
1
E.IA. .ENG- TS A.11