TESVOLT TS25, Installation Manual

Page: 7 / 34

3 Needed tools
WARNING!
Acid burns and poisoning from the battery electrolyte or poisonous gases:
Electrolyte or poisonous gases cannot escape from the battery pack under normal operating conditions. Despite
careful design and manufacture, damage to the battery pack resulting from fault can result in escaping electrolyte or
low concentrations of poisonous gases, organic solvent gases and hydrogen fluoride acids.
Store the battery pack in a dry place and within the temperature range specified in the datasheet.
Do not allow the battery pack to fall down
Do not open the battery pack
Never install or operate the battery pack in potentially explosive
environments or areas with relatively high humidity levels
In the case of contact with electrolyte, immediately wash the affected
area with water and seek medical advice
Needed Tools
Description
Battery 13 mm attachment for the battery poles and APU connections Torque wrench
For fixing the battery modules and APU in the battery cabinet Cross-head screwdriver
Optional: For removing the cover of the battery rack 8 mm hex key
Optional: For moving the cable entry on the cover
of the battery rack
TX 25 Torx screwdriver
Optional: For removing the side panels of the battery rack
TX 30 Torx screwdriver
For connecting the control and measuring cables
to the Sunny Island terminal Slot-head screwdriver Sunny Island
For mounting the Sunny Island wall bracket
Power drill and drill bits
For removing the cover of the Sunny Island 5 mm hex key
For crimping the lugs of the DC cable 50 to 120 sq. mm crimping pliers
For crimping the wire end ferrules Ferrule crimper
For measuring the grid and battery voltage
(operating voltage up to 60 V (DC) for TS 48 V)
Voltage measuring device
Sunny Island
www.tesvolt.com
5
E.IA. .ENG- TS A.11