Terex Genie S-60 DC, Service And Repair Manual

Page: 69 / 171

July 2021 Service and Repair Manual
Turntable Rotation Components
Part No. 1299608GT S ® -60 DC • S ® -60 FE 57
3 Push the backlash pivot plate towards the
turntable as far as possible (this will push the
rotation gear into the turntable bearing ring
gear).
4 Loosen the lock nut on the adjustment bolt.
5 Turn the adjustment bolt clockwise until it
contacts the backlash pivot plate.
6 Turn the adjustment bolt 1/2 turn
counterclockwise. Tighten the lock nut on the
adjustment bolt.
7 Rotate the backlash pivot plate away from the
turntable until it contacts the adjustment bolt.
Then torque the mounting fasteners on the
backlash pivot plate to specification. Refer to
Specifications, Machine Torque
Specifications
.
8 Rotate the turntable through an entire
rotation. Check for tight spots that could
cause binding. Readjust if necessary.
9-2
How to Replace the Universal Tilt
Sensor (UTS)
This machine has a dual axis angle-sensing
device called the Universal Tilt Sensor (UTS). It is
mounted on the turntable to monitor and
communicate ground angle relative to gravity via
CAN bus. Should the turntable be tilted at the
Allowable Tilt Angle
or greater an alarm will sound
at both the turntable and the platform. If not
calibrated, the machine will only drive in the
stowed configuration in turtle mode.
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
1 Push in the red Emergency Stop button to the
off position.
2 Tag and disconnect the harness from the tilt
sensor.
Note: Record the X and Y axis orientation of the tilt
sensor.
3 Remove the fasteners securing the tilt sensor
to the turntable.
4 Secure the new tilt sensor using the existing
fasteners removed in step 3. Tighten the
fasteners.
5 Calibrate the tilt sensor. Refer to Repair
Procedure,
How to Calibrate the Universal Tilt
Sensor
.