Terex Genie S-60 DC, Service And Repair Manual

Page: 52 / 171

Service and Repair Manual July 2021
Boom Components
40 S ® -60 DC • S ® -60 FE Part No. 1299608GT
4-6
Primary Boom Angle Sensor
The primary boom angle sensor is used to limit the
angle of the primary boom relative to the angle of
the turntable and gravity.
How to Replace the Primary
Boom Angle Sensor
Note: If the angle sensor is replaced, both the
sensor and magnet must be replaced as a set.
1 Push in the red Emergency Stop button to the
off position at both the ground and platform
controls and turn the key switch to the off
position.
2 Locate the boom angle sensor on the primary
boom.
3 Tag and disconnect the electrical connector
from the angle sensor.
4 Remove the retaining fasteners. Remove the
angle sensor and magnet from the machine.
5 Install the new angle sensor and magnet onto
the machine.
6 Securely connect the angle sensor harness to
the main harness.
7 Calibrate the primary boom angle sensor.
Refer to Repair Procedure,
How to Calibrate
the Primary Boom Angle Sensor
.