Service and Repair Manual
July 2021
Control System Fault Codes
76
S
®
-60 DC • S
®
-60 FE
Part No. 1299608GT
Error Source
Error Type
ID Component
ID Name
Cause
Effect
Solution
135
WALL POWERED
CHARGER ERROR
CODES
7 Ah Limit
Exceeded
Safety limit exceeded, possible causes:
·
Poor battery health.
·
Discharged battery.
·
Poorly connected battery.
·
High parasitic loads on battery while
charging.
·
Replace battery pack
·
Check DC
connections
·
Disconnect parasitic
loads
(This error will
automatically clear
once the charger is
reset by cycling DC.)
8
Battery
temperature out
of range error
Battery temperature sensor error.
·
Check temperature
sensor and
connections
·
Reset charger
(This error will
automatically clear
once the condition has
been corrected.)
Condition has been
corrected.)
11
Charger is
disabled by
external
command
12 Reverse polarity
error
Battery is connected the wrong way
around.
·
Check the battery
connections.
(This error will
automatically clear
once the condition has
been corrected.)
13 Battery does not
take current
Battery voltage is detected but the
charger is unable to charge the battery.
This can be due to an electrical device
connected between the charger and
the battery, which passes through
voltage but not current. Or if an
algorithm is installed that does not
require battery voltage then the
charger can try to charge, but if it
cannot supply current then this fault
would be seen (Lithium application with
a BMS perhaps).
Ensure the charger is
properly connected to
approved equipment
(This error will
automatically clear
once the charger is
reset by cycling DC.)
16 Software upgrade
failure
Ensure the USB Flash
Drive is properly
formatted and retry the
update by reinserting
the USB Flash Drive
into the charger.
Summary of Contents for Genie S-60 DC
