Terex Genie S-60 DC, Service And Repair Manual

Page: 40 / 171

Service and Repair Manual July 2021
Jib Boom Components
28 S ® -60 DC • S ® -60 FE Part No. 1299608GT
How to Reset Overload Recovery Message How to Reset Overload Recovery
Faults
The message OVERLOAD RECOVERY will be
displayed when a platform overload recovery
occurs under auxiliary power. The message will
persist until the reset overload recovery procedure
is performed. Refer to Navigation Menus, Faults
Menu.
1 Turn the key switch to platform controls.
2 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
3 Do not press down the foot switch.
4 Move and hold the drive enable toggle switch
in the right direction while holding steer in the
right direction.
5 When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and the steer joystick.
Result: The display will show FAULTS.
6 Momentarily activate the drive enable toggle
switch in the right direction until ACTIVE
FAULTS is shown on the display.
7 Activate steer in the right direction until
RESET OVERLOAD RECOVERY is shown
on the display.
8 Momentarily activate the drive enable toggle
switch in the right direction to lock the menu
OVERLOAD RECOVERY RESET.
9 Enter the reset code by momentarily
activating steer right three times then steer
left one time.
Result: A one second pulse alarm will sound
indicating the reset procedure has been
saved.
2-4
Platform
How to Remove the Platform
1 Remove the cable clamp from the top of the
platform mounting weldment.
2 Remove the mounting fasteners from the
power to platform outlet box bracket. Lay the
outlet box and bracket assembly off to the
side. Do not disconnect the wiring.
3 Remove the foot switch mounting fasteners.
4 Remove the cover plate from the bottom of
the foot switch to access the foot switch wire
terminals.
5 Tag and disconnect the foot switch wiring
from the foot switch. Remove the cable from
the back of the platform.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
6 Remove the platform control box mounting
fasteners. Lower the control box and set it
aside.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
Note: If your machine is equipped with an airline to
platform option, the airline must be disconnected
from the platform before removal.
7 Support and secure the platform to an
appropriate lifting device.
8 Remove the platform mounting fasteners and
remove the platform from the machine.
Crushing hazard. The platform
could become unstable and fall
when it is removed from the
machine if not properly
supported.