OLT6 and 1134 Description Installation and Turnup Guide
Page 41 of 50
Number of ESU cards: ............................................................. [2] : 2
Number of Uplink Interfaces (NETs/LAGs) for element management: (1-2)............. [1] : 1
Configuration Details for Uplink Interface #1:
AID of Uplink Interface #1: (NET1)........................................... [NET1] :
NET1
Port speed for NET1: (1G(1), 10G(2))............................................ [2] : 2
Number of ports for NET1: (1-2)................................................. [2] : 2
Enable Link Aggregation Control Protocol (LACP) for NET1: (y/n)................. [Y] : Y
Element Management Traffic tagging: (untagged-1, tagged-2)...................... [2] : 2
VLAN Interface (SVI) for Element Management:
VLAN ID for Element Management Communication: (1-4094)......................... [2992] :
2992
VLAN Priority for Element Management communication: (0-7)......................... [7] : 7
IP Stack Type to use: (IPv4(1), IPv6(2), Dual(3))................................. [1] : 1
IPV4 Configuration:
Address: (IPv4 address )........................................................
[172.28.25.201] : 172.28.25.201
Network Mask: ..................................................................
[255.255.255.0] : 255.255.255.0
Default Gateway: ...............................................................
[172.28.25.203] : 172.28.25.203
CLI commands, parameters and options can be entered using abbreviations. The
abbreviations are specified with capitalization in the help listings and context menus.
For example, the wizard command is displayed in the help listing as
WIZard
. This case
convention indicates that the command can be invoked using either
wizard
or the
abbreviated form
wiz
.
The CLI also provides for tab completion to speed input. Usually, typing the first
character of the command, parameter or option and then pressing
Tab
will provide
command auto completion.
·
The wizard will prompt for all required turnup information. Valid choices for each
configuration item are displayed in parentheses with each prompt. The wizard
attempts to guide the user by providing a default value, shown in [brackets], at
the end of each prompt. To accept the default value press
Enter
. Otherwise,
enter the appropriate value and press
Enter
. The following information will be
collected by the wizard:
Number of Uplink Interfaces
Typically, it is best to configure only a single management interface during turnup.
Additional interfaces can be provisioned after the OLT has been added to
Panorama. Panorama enables configuration of all OLT elements, including some
items that are not configurable from the CLI. The goal of turnup is to initialize the
system such that Panorama can be used to complete configuration.
