Eclipse 8/ 16/ 32 Series - Engineer Programming Manual
67
PH1
NUMBER
ADDRESS
6010
OPERATION
610 +01
TEXT MENU
8. COMMUNICATION – 1. DIGITAL COMM – 5. PHONES – 1. PHONE – 1. PHONE NUMBER
Setting of Telephone 1 for the digital communicator
A Telephone 1 number is assigned for communicating with central station. The telephone number
must not exceed 32 characters. Some special functions can be entered by using the next button
combinations:
1. Buttons
/
+ 0 - Switches on "pulse dialer".
“P” letter is displayed on the screen.
2. Buttons
/
+ 1 - Switches on "tone dialer".
“T” letter is displayed on the screen.
3. Buttons
/
+ 2 - 2 seconds pause.
“D” letter is displayed on the screen.
4. Buttons
/
+ 3 - Switches on "Wait dial tone".
“
” symbol is displayed on the screen.
5. Buttons
/
+ 4 - "Blind dialing"; Switches off "Wait dial tone".
“#” symbol is displayed on the
screen.
6. Buttons
/
+ 5 - Deletes the entered telephone number.
Note: The
button is used in the previous design of the keyboards and has the same
functionality.
Default setting: none
PH1
PROTOCOL
ADDRESS
6011
OPERATION
611 + 01
TEXT MENU
8. COMMUNICATION – 1. DIGITAL COMM– 5. PHONES – 1. PHONE – 2. PROTOCOL
Setting the communication protocol for Telephone 1
The engineer sets the communication protocol type for Telephone 1 at the address. The supported
communication protocols are CID and SIA.
Every pressing of random key switches alternatively between the two protocols. Confirm you choice
with ENTER button.
Default setting: CID
PH1
MESSAGES
ADDRESS
6012
OPERATION
612 + 01
TEXT MENU
8. COMMUNICATION – 1. DIGITAL COMM– 5. PHONES – 1. PHONE – 3. MESSAGES TYPE
Setting of alarm messages for Telephone 1
At this address are assigned the one or more type of the messages which will be transmitted to a
central monitoring station in case of alarm condition through Telephone 1.
To the Telephone 1 can be programmed to be transmitted only chosen messages. In case the user
wants some messages to be transmitted and through telephone number 2 (3, 4 or all), then the
same chosen messages have to be assigned and at ADDRESS 6022 (6032, 6042). If it does not
matter through which of the telephone numbers the messages are sent, you have to leave the
ADDRESS 6022 (6032,6042) with its default programming (No messages are assigned).
The digit buttons 1 to 8 are used for programming. Pressing them each time will alternatively change
the status of the respective message type - report (active status of the parameter) or no report
(inactive status of the parameter). At the end of the procedure only those parameters, which
correspond to the designated for report messages, should remain activated on the display.
The following messages are assigned:
1
ALARM
Message is sent in case of events:
- ALARM
- ALARM Restore
