Confi g-if level for data channels
On confi g-if level for data channel the user is able to change device’s data interface
settings. Confi g-if level for data channel is activated by entering command interface
datachannel [1/2/3] (or in d 1/2/3) on confi g level --> “
IPx(config-if)#
” text
appears on the screen. Entering ? displays a list of commands for confi g-if level for
data channel. To read device settings, the user must return to enable level by
entering command end (or en).
Commands:
baudrate (b) [baudrate] - Set data channel’s baudrate to 1200 (12), 2400 (2),
4800 (4), 9600 (9), 1440 (14), 19200 (19), 38400 (3), 57600 (5) or 115200 (11)
channel-mode (c) [mode] - Set data channel service mode to client (c),
server (s) or virtual-bus (v)
databits (d) [5-9] - Set number of data bits per byte
end (en) - Back to enable level
exit (ex) - Back to confi g level
ip address (i a) [IP address] - Set destination IP address or multicast group
ip port (i p) [1024-65535] - Set IP port to receive/send data
ip time-to-live (i t) [1-255] - Set time-to-live (TTL) value
no ip (n i a) [IP address] - Clear destination IP address or multicast group
no shutdown (n s) - Enable data channel service
quit (q) - Back to confi g level
shutdown (sh) - Disable data channel service
signaling (si) [mode] - Set the signaling type to RS232 (rs-2), RS422 (rs-42),
RS485 (rs-485) or RS485-4wire (rs-485-)
stopbits (st) [1-2] - Set stop bits
Picture 38.
Confi g-if level for data channel’s “?” view.
IPx(config-if)#
baudrate Serial connection baudrate
channel-mode Data channel service setup
databits Number of data bits per byte
end End current mode and down to previous mode
exit Exit current mode and down to previous mode
ip IP settings
no Negate a command or set its defaults
quit Exit current mode and down to previous mode
shutdown Disable data channel service
signaling Set the signaling type
stopbits Number of stop bits in byte
IPx(config-if)#
BLUEbox series CLI user manual rev002
27