Teledyne T200H, User Manual, Page: 173 / 353

Teledyne API - Model T200H/T200M Operation Manual Operating Instructions
171
To initialize the modem press:
Select which
COM Port is
tested
SETUP X.X
SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SETUP X.X
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE A1:NXCNC1=100PPM NOX=XXX.X
< TST TST > CAL SETUP
SETUP X.X COMMUNICATIONS MENU
ID COM1 COM2 EXIT
EXIT returns
to the
previous
menu
SETUP X.X COM1 MODEM INIT:AT Y
∅
&D
∅
&H
<SET SET> EDIT EXIT
S
ETUP X.X COM1 INITIALIZE MODEM
<SET SET> INIT EXIT
SETUP X.X COM1 MODE:0
SET> EDIT EXIT
SETUP X.X COM1 BAUD RATE:19200
<SET SET> EDIT EXIT
EXIT returns to the
Communications Menu.
S
ETUP X.X INITIALIZING MODEM
<SET SET> INIT EXIT
4.15.2.7. COM Port Password Security
In order to provide security for remote access of the T200H/M, a LOGON feature can be
enabled to require a password before the instrument will accept commands. This is done
by turning on the
SECURITY MODE (see Section 4.9). Once the SECURITY
MODE is enabled, the following items apply.
•
A password is required before the port will respond or pass on commands.
•
If the port is inactive for one hour, it will automatically logoff, which can also be
achieved with the LOGOFF command.
•
Three unsuccessful attempts to log on with an incorrect password will cause
subsequent logins to be disabled for 1 hour, even if the correct password is used.
•
If not logged on, the only active command is the '?' request for the help screen.
•
The following messages will be returned at logon:
o
LOGON SUCCESSFUL - Correct password given
o
LOGON FAILED - Password not given or incorrect
o
LOGOFF SUCCESSFUL - Connection terminated successfully
To log on to the T200H/M analyzer with SECURITY MODE feature enabled, type:
LOGON 940331
940331 is the default password. To change the default password, use the variable
RS232_PASS issued as follows:
V RS232_PASS=NNNNNN
Where N is any numeral between 0 and 9.
07270D DCN7141