![background image](http://html1.mh-extra.com/html/tektronix/tms-600-sab-c167-80c167/tms-600-sab-c167-80c167_instruction-manual_1078308020.webp)
Getting Started
1–4
TMS 600 SAB-C167 80C167 Microcontroller Support Instruction Manual
Connecting to a System Under Test
Before you connect to the SUT, you must connect the probes to the module.
Your SUT must also have a minimum amount of clear space surrounding the
microcontroller to accommodate the probe adapter. Refer to the Specifications
chapter in this manual for the required clearances.
The channel and clock probes shown in this chapter are for a 102/136-channel
module. The probes will look different if you are using a 96-channel module.
The general requirements and restrictions of microcontroller supports in the
information on basic operations shows the vertical dimensions of a channel or
clock probe connected to square pins on a circuit board.
To connect the logic analyzer to a SUT using a PQFP probe adapter, follow these
steps:
1. Turn off power to your SUT. It is not necessary to turn off the logic analyzer.
CAUTION.
Static discharge can damage the microcontroller, the probe adapter,
the probes, or the module. To prevent static damage, handle all the above only in
a static-free environment.
Always wear a grounding wrist strap or similar device while handling the
microcontroller and probe adapter.
2. To discharge your stored static electricity, touch the ground connector located
on the back of the logic analyzer. Then, touch any of the ground pins of the
probe adapter to discharge stored static electricity from the probe adapter.
3. Line up pin 1 on the 144 pin EIAJ QFP test clip, to pin 1 on the connector
located on the bottom of the probe adapter circuit board, as shown in
Figure 1–2.
With a PQFP Probe
Adapter
Summary of Contents for TMS 600 SAB-C167 80C167
