Tektronix TMS 600 SAB-C167 80C167, Instruction Manual

Page: 24 / 94

Getting Started
1–8
TMS 600 SAB-C167 80C167 Microcontroller Support Instruction Manual
6. Connect the channel and clock probes to the high-density probe as shown in
Figure 1–5. Match the channel groups and numbers on the probe labels to the
corresponding pins on the high-density probe. Match the ground pins on the
probes to the corresponding pins on the probe adapter.
Clock probe
Channel probe
and podlet holder
Hold the channel probes by the podlet
holder when connecting them to the
high-density probe. Do not hold them
by the cables or necks of the podlets.
High-density probe
Channels connect to
the logic analyzer
Figure 1–5: Connecting channel and clock probes to a high-density probe
7. Measure the resistance between Vcc and ground to verify that they are not
shorted together. If you detect a short, determine the source and repair the
problem before applying power.
You can use channel probes, clock probes, and leadsets with a commercial test
clip (or adapter) to make connections between the logic analyzer and your SUT.
To connect the probes to 80C167 signals on the SUT using a test clip, follow
these steps:
1. Turn off power to your SUT. It is not necessary to turn off power to the logic
analyzer.
Without a Probe Adapter