Tektronix TMS 600 SAB-C167 80C167, Instruction Manual

Page: 18 / 94

Getting Started
1–2
TMS 600 SAB-C167 80C167 Microcontroller Support Instruction Manual
To use this support efficiently, you need to have the items listed in the informa-
tion on basic operations as well as:
H
C167 User’s Manual, Siemens, August 1994
H
C16x Instruction Set Manual, Siemens, September 1995
Information on basic operations also contains a general description of supports.
Logic Analyzer Software Compatibility
The label on the microcontroller support floppy disk states which version of logic
analyzer software the support is compatible with.
Logic Analyzer Configuration
To use the 80C167 support, the Tektronix logic analyzer must be equipped with
either a 102/136-channel module, or a 96-channel module at a minimum. The
module must be equipped with enough probes to acquire channel and clock data
from signals in your 80C167-based system.
Refer to information on basic operations to determine how many modules and
probes the logic analyzer needs to meet the channel requirements.
Requirements and Restrictions
You should review the general requirements and restrictions of microcontroller
supports in the information on basic operations as they pertain to your SUT.
You should also review electrical, environmental, and mechanical specifications
in the Specifications chapter in this manual as they pertain to your system under
test, as well as the following descriptions of other 80C167 support requirements
and restrictions.
System Clock Rate.
The TMS 600 support can acquire data from the 80C167
microcontroller at speeds of up to 20 MHz
1
; it has been tested to 5 MHz.
Hardware Reset.
If a hardware reset occurs in your 80C167 system during an
acquisition, the disassembler might acquire an invalid sample.
1
Specification at time of printing. Contact your Tektronix sales representative for
current information on the fastest devices supported.