Tektronix TLA7AA1, Manual, Page: 86 / 173

Performance Verification
TLA7AXX Logic Analyzer Module Service Manual
4- 19
6. Connect any one of the coaxial cables from the TV (test voltage) connectors
on the test fixture to the TV connector on the MIC.
7. Connect the multimeter leads to the DMM test points (J390) on the test
fixture. Connect the positive lead to the + connector and the negative
(ground) lead to the -- connector.
8. Connect a P6041 cable from each of the Analog Output BNC connectors to
the corresponding connector on the front of the test fixture (if necessary,
refer to the label on the test fixture for the connection locations).
9. Connect the ribbon cables with the MICs to the appropriate connector on the
logic analyzer module.
10. Power on the test fixture and the logic analyzer and allow a 30 minute
warm--up period.
Start the Software.
Complete the following steps to start the software:
1. Exit the TLA application on the logic analyzer.
2.
Double-click the TLA7Axx Performance Verification icon on the desktop.
An application window similar to Figure 4--2 on page 4--5 appears.
3. If you have more than one logic analyzer module in your mainframe, select
the logic analyzer module to be verified from the list in the window.
4. Click the Verification button to start the software. A Verification dialog box
similar to Figure 4--4 on page 4--17 appears.
5.
Select Input Resistance, Digital Gain and Offset, and Analog Gain and
Offset and clear any other procedures.
NOTE
. The software will perform all selected procedures without interruption. To
limit the test to specific procedures, clear any procedures that you do not want to
run.
6. Click the Next button at the bottom of the dialog box to begin the procedure.
A list of connection instructions displays for the current procedure.
7. Verify that your connections match those of the instructions. Then click the
Next button to begin the procedures.
The software will begin the verification procedures and display a list of
results in the window.