Tektronix TLA7AA1, Manual, Page: 41 / 173

Specifications
1- 14
TLA7AXX Logic Analyzer Module Service Manual
Table 1- 12: TLACAL2 Performance verification and adjustment fixture characteristics
Characteristic Description
Input channels One external clock input
Input voltage < 1 V referenced to ground, 50
Ω
termination
P6860 deskew and minimum pulse timing
outputs 34 + 5 grouped into three P6860 connectors, two with 17 channels and one with five
channels
P6860-setup and hold outputs 136 grouped into eight 17-channel connectors
P6880 deskew and minimum pulse timing
outputs 34 + 5 grouped into three P6860 connectors, two with 17 channels and one with five
channels
P6860/80 gain and offset outputs 68 grouped into four 17-channel connectors
P6810 gain and offset outputs 34 grouped into four 8-channel connectors and one 2-channel connector for the clocks
Analog output SMB inputs Four inputs with 50
Ω
termination each
DMM test points One connection to a GPIB-controlled digital voltmeter
Number of module interface connector (MIC)
boards connected at one time Four. Each board requires a ribbon cable and two MCX cable attachments to the main
board
Number of Probe interface connector (PIC)
boards connected at one time One. The board must be connected to the ribbon connector labeled PIC.
Timing section output amplitude 100E Motorola ECLinPS family outputs referenced to +2 V amplitude
Gain/Offset output voltage range --5 V to +5 V
MIC board test current range
¦
3 mA
Interface ports
RS-232 9-pin RS-232 serial communications interface
JTAG Programming interface for the xilinx CPLD
Power distribution system
Power consumption 40 W maximum
Source voltage and frequency 100 V
RMS
to 240 V
RMS
±
10%, 50 Hz to 60 Hz continuous range CAT II
115 V
RMS
±
10%, 400 Hz, continuous range CAT II
Fuse ratings
100 V to 120 V operation
200 V to 240 V operation
Internal power supply
5.0 mm x 20 mm, 1.0 A FAST 250 V; Tektronix part number 159-0356-00
5.0 mm x 20 mm, 0.5 A FAST 250 V; Tektronix part number 159-0351-00
5.0 mm x 20 mm, 3.15 A, 250 V