Tektronix TLA Series, Service Manual

Page: 88 / 130

Removal and Installation Procedures
6- 10
TLA Series Digitizing Oscilloscope Modules Service Manual
Cover
You will need a screwdriver with a size T-10 Torx
R
tip (Table 6--3, items 1
and 2) to replace the cover.
Use the following procedure and Figure 6--2 to remove the cover.
1.
Place the module on its right side (power-requirements label facing down).
2.
Remove four (4) screws that secure the rear panel to the chassis (Figure 6--2).
Set the rear panel aside.
3.
Remove four (4) screws that secure the cover to the chassis.
4.
Lift the cover from the chassis.
Rear panel
Cover
Chassis
Remove screws (8)
Figure 6- 2: Cover removal
Removal