Tektronix TLA Series, Service Manual

Page: 32 / 130

Operating Information
2- 4
TLA Series Digitizing Oscilloscope Modules Service Manual
Use the following procedure to remove the DSO module from a mainframe.
1.
Power off the mainframe.
2.
Using a screwdriver, loosen the top and bottom retainer screws (Figure 2--2).
3.
Grasp the ejector handles on the DSO module. At the same time, move the
top handle upward and the bottom handle downward to eject the DSO
module.
4.
Pull the DSO module out of the mainframe.
Software Installation and Removal
These procedures describe loading and unloading the performance verification
and adjustment software. Refer to the
Tektronix Logic Analyzer Family User
Manual
for information on installing or removing any other software. It is
recommended you have
≥
10 MB of free space on the hard drive before installing
the software. The Performance Verification software is located on Disk 1 of the
Tektronix Logic Analyzer Family Application Software CD.
NOTE
. This installation program uses parameters you supply to create a custom
start-up file in your hard disk directory.
The batch file enables the software to configure your instrument properly before
it runs the program.
1.
Power on the instrument.
2.
Exit the Application.
If your logic analyzer already has PV/Adjust software loaded on it, you must
verify that the version is the same as the version printed on Disc 1 of the
Tektronix Logic Analyzer Family Application Software CD.
If the version of the PV/Adjust software loaded on your logic analyzer is an
earlier version, you must delete the earlier version before you can load the newer
version.
If your logic analyzer already has a directory named Tekcats or Temptek on the
hard drive, the software installation cannot be completed. Follow these instruc-
tions to verify the directory is not present:
1.
Select Start
→
Search
→
For Files or Folders.
Removing the DSO
module from the
Mainframe
Verify PV/Adjust Software
Version
Verify Directories