Tektronix TLA Series, Service Manual

Page: 86 / 130

Removal and Installation Procedures
6- 8
TLA Series Digitizing Oscilloscope Modules Service Manual
Tools Required
Most modules in the DSO module can be removed using a screwdriver handle
mounted with size T-10 and T-15 Torx
R
screwdriver bits. Table 6--3 lists the
tools needed to replace modules in the DSO module.
Table 6- 3: Tools required for parts replacement
Item
number
Name Description
1 Screwdriver handle Accepts Torx
R
driver bits
2 T-10 Torx tip Torx
R
driver bit for T-10 size screw heads
3 T-15 Torx tip Torx
R
driver bit for T-15 size screw heads
4 One-half inch (1/2) nut driver Standard tool
5 One-quarter (1/4) inch nut driver Standard tool
6 Soldering iron Standard tool
7 Solder wick Standard tool
8 Three-sixteenth (3/16) inch nut
driver Standard tool
Injector/Ejector Handles
You will need a screwdriver with a size T-10 Torx
R
tip (Table 6--3, items 1
and 2) to replace the ejector handles.
Use the following procedure and Figure 6--1 to remove the injector/ejector
handles.
1.
Place the DSO module on its right side.
2.
Remove the two screws that secure the injector/ejector handle to the chassis.
3.
Remove the injector/ejector handle from the DSO module.
Removal