Maintenance
Maintenance
This section contains maintenance information for your probe.
Error condition
The TAP2500, TAP3500, and TAP4000 active probes are designed to work with all TekVPI-interface oscilloscopes and adapters.
However, there may be some cases where all of the probe features may not work properly.
If the Status LED glows red during or after probe power on, an internal probe diagnostic fault exists. Disconnect and reconnect the
probe to restart the power-on diagnostic sequence. If the Status LED continues to glow red, the probe is defective, and must
be returned to Tektronix for repair.
Replacement parts
There are no user replaceable parts within the probe. Refer to
Accessories
for a list of replaceable accessories for your probe.
60
TAP2500, TAP3500, and TAP4000 Instruction Manual
