Installation
Diagnostics
Run a complete Diagnostics test session as follows:
1.
Select
Tools > Diagnostics
from the menu bar.
2.
Select the
All Modules, All Tests
check box at the top of the list.
3.
Click the
RUN
button. The diagnostics tests will take some time to complete, and the following is interactive:
a.
Noise Source Drive 28 V DC Out diagnostic will ask you to test the noise source output on the RSA7100 rear-panel.
Check with a voltmeter that the voltage is 28 V ±2 V.
4.
When all diagnostics tests have completed, check that there is a check mark beside each diagnostic name. An X instead
of a check mark indicates that the diagnostic had a failure.
5.
Click the
Diagnostics Failure
Info tab and verify there is no failure information listed.
6.
Click the
Exit Diagnostics
button to exit diagnostics.
How to activate Microsoft Windows 10
The version of Microsoft Windows 10 that ships with this product is shipped in Deferred Activation mode. Microsoft has
a default activation method that requires a connection to the Internet. If you do not have a connection, you can activate
Windows 10 by phone or you can continue to operate in Deferred Activation mode.
First time activation
You can activate Windows 10 two ways.
1.
Connect to the Internet. Windows will automatically activate. You can also go to System Properties to connect and
activate.
2.
Call Microsoft and speak with a representative to activate Windows 10. Contact information and a unique activation
code (installation ID) will appear in a pop up window.
Activation with removable drives
If the SSD/HD is removed from one controller and inserted into another controller, then the activation process will need to run
again. If controller 2 is not connected to the Internet, the activation will fail and an Activate Windows watermark will display
on the screen. To activate Windows and remove the watermark, you must connect to the Internet or call Microsoft.
RSA7100 Series Quick Start User Manual
13
